Figure 71. CMA arms and separators
R
emove the system from the cabinet
Steps
1. At the front of the cabinet, locate the two slam latches on left and right side of the system. Pull the slam latches up to
release the system from the cabinet. If the slam latches do not disengage, loosen the screw under each latch.
2. Using the slam latches, pull the system from the cabinet until the rails lock in the extended position.
Figure 72. Release and extend system from cabinet
3. Locate the lock levers on the sides of the inner rails (1). Unlock each lever by rotating it up to its release position (2). Grasp
the sides of the system (3) firmly and pull it forward until the standoffs are at the front of the J-slots in the rails. Lift the
system up and away from the rails.
136 Replace the Rail Kit
To Next Page
Loading...
