Replace the HBA330 SAS Controller
T
he system uses an HBA330 SAS controller card .
Complete the following procedure to replace the HBA330.
This CRU is not hot-swappable, and requires a system shutdown to replace.
Topics:
• Verify the status of the HBA330
• Shut down and disconnect the system
• Extend the system from the cabinet
• Remove the system cover
• Remove expansion card riser 1
• Remove the integrated storage controller card
• Install the integrated storage controller card
• Install expansion card riser 1
• Install the system cover
• Slide the system into the cabinet
• Reconnect and power on the system
• Verify the replacement HBA330
• Restore the HA configuration
Verify the status of the HBA330
Prerequisites
Establish a connection to the system as described in Establish a serial management connection to the PowerProtect system on
page 14.
About this task
Complete the following steps to verify the HBA330.
NOTE:
The DD OS software lists the HBA330 as PERC1 Dell Storage Cntlr.12GB-SASHBA
Steps
R
un the disk show hardware command, and if any of the following disks are not reported, the HBA 330 requires
replacement:
# d
isk show hardware
Disk Slot Manufacturer/Model Firmware Serial No. Capacity Type
(enc/disk)
---------- ---- ------------------------ -------- -------------- --------
-------
1.1 0 SAMSUNG MZILT1T9HAJQ0D3 DSF8 S40DNF0K906928 1.7 TiB
SAS-SSD
1.2 1 SAMSUNG MZILT1T9HAJQ0D3 DSF8 S40DNF0K906926 1.7 TiB
SAS-SSD
1.3 2 SAMSUNG MZILT1T9HAJQ0D3 DSF8 S40DNF0K906902 1.7 TiB
SAS-SSD
1.4 3 SAMSUNG MZILT1T9HAJQ0D3 DSF8 S40DNF0K906904 1.7 TiB
SAS-SSD
11
84 Replace the HBA330 SAS Controller
To Next Page
Loading...
