Extend the system from the cabinet
U
se this procedure to extend the system from the cabinet so that you can remove the system cover to access the internal FRU
components, or to remove the system from the cabinet.
Steps
1. At the front of the cabinet, locate the two slam latches on the left and right sides of the system. Pull the slam latches up to
release the system from the cabinet. If the slam latches do not disengage, loosen the screw under each latch.
2. Using the slam latches, pull the system from the cabinet until the rails lock in the extended position.
Replace the system board 107
To Next Page
Loading...
