Remove expansion card riser 1
P
rerequisites
Follow the safety guidelines.
Steps
1. If installed, remove the expansion cards from the riser.
2. Disconnect any cables connected to the riser.
3. Press the release latches, and lift the riser from the riser connector on the system board.
Figure 40. Removing expansion card riser 1
R
emove the integrated storage controller card
Prerequisites
Follow the safety instructions.
Steps
1. Using a Phillips #2 screwdriver, loosen the screws that secure the integrated storage controller cable to the connector on
the system board.
2. Lift the integrated storage controller cable away from the integrated storage controller.
Replace the HBA330 SAS Controller 87
To Next Page
Loading...
