Dell PowerProtect DD6900 - Install Integrated Storage Controller Card

Figure 59. Installing a memory module
I
nstall the integrated storage controller card
Prerequisites
Follow the safety instructions.
Steps
1. Hold the interposer board by its edges and align the interposer board connector with the connector on the system board.
2. Press the touch point on the interposer board until the interposer board connector is firmly seated on the system board
connector.
3. Angle the card to engage the card with the integrated storage controller card holder on the system board.
4. Lower the card into place until the card is fully seated in the integrated storage controller card holder.
Figure 60. Installing the integrated storage controller card
5
. Route the integrated storage controller card cable along the wall of the system.
6. Align the screws on the integrated storage controller card cable with the screw holes on the connector.
118 Replace the system board