6. Use the release handle to pull the node outward enough to grasp the sides with both hands. Then, with both hands
supporting the node, pull the node fully out of the enclosure.
Figure 117. Removing the node
7. Place the node on a clean, flat, static-free work surface.
Remove the top cover from the node
Steps
1. While pushing down the two blue release buttons, slide the top cover towards the rear of the system, until it stops.
Figure 118. Releasing the top cover
2. Lift the top cover upward, and remove it from the node.
Base enclosure service procedures
103
To Next Page
Loading...
