Dell PowerStore 1000 - Verify the Operation of a Replacement DIMM

A
B
1
1
2
2
Figure 203. Installing the Access Module
2. Press in on the Access Module latches to lock them into place.
A
B
1
1
2
2
Figure 204. Locking the Access Module into place
3. Connect the cables to the Access Module.
Verify the operation of a replacement DIMM
Steps
1. From PowerStore Manager, select Hardware.
2. Select the appliance where you replaced the DIMM.
3. On the Components card, under Internal View, expand ExpansionEnclosure.
4. Select the relevant DIMM.
The status of the replacement DIMM should read Healthy. If the status is still Faulted, wait a few minutes and refresh
PowerStore Manager. If the status does not change, ensure that the DIMM is correctly seated, or contact your service
provider.
170
NVMe expansion enclosure service procedures