4. If the bezel has a key lock, lock the bezel with the provided key.
Figure 16. Installing the bezel
Connect SAS expansion enclosure power cables
Steps
1. Connect the power cable to the power/cooling module:
Figure 17. Attaching power cable
2. Attach the retention bail (strain relief) to the base of the power cable.
The retention bail prevents the power cable from pulling out of the connection.
Cable the new SAS expansion enclosure
Follow these guidelines to cable an expansion enclosure in a running system to a new expansion enclosure.
Prerequisites
Apply cable labels to the cables connecting the expansion enclosures. In this procedure, "last expansion enclosure" refers to the
last expansion enclosure that is currently installed. The "new expansion enclosure" refers to the expansion enclosure that you
are adding in this procedure.
26
Install a new base enclosure and an optional expansion enclosure
To Next Page
Loading...
