● Do not seat one end of the DIMM and then the other.
Figure 110. Installing the DIMM
3. Proper DIMM insertion will automatically close the latch ejectors and lock the DIMM into the socket. Verify that the latch
ejectors are fully closed and have engaged the notches in the DIMM.
Install the top cover on the node
Steps
1. Position the top cover over the node and align it with the slots in the sides at the rear of the node.
Figure 111. Aligning the top cover
2. Pull the top cover forward to secure it in place.
98
Base enclosure service procedures
To Next Page
Loading...
