Transferring the internal battery backup
module
Learn how to transfer the internal battery backup module from a faulted node to a replacement node.
NOTE: Review the information in Safety precautions for handling replaceable units before handling replaceable parts.
Topics:
• Remove the internal battery backup module
• Install the internal battery backup module
Remove the internal battery backup module
Steps
1. Lift the gray padding away from the internal battery backup module.
2. Remove the clip around the internal battery backup module by pulling the tab on the left side.
3. Disconnect the internal battery backup module cable from the motherboard.
Figure 205. Releasing the BBU
4. Lift the internal battery backup module away from the motherboard.
C
Transferring the internal battery backup module 189
To Next Page
Loading...
