Figure 156. Installing a drive
The activity light flashes to indicate that the spin-up sequence has begun.
Installing the front bezel
Steps
1. Align the bezel with the enclosure.
2. Gently push the bezel into place on the cabinet until it latches.
3. If the bezel has a key lock, lock the bezel with the provided key.
Figure 157. Installing the bezel
Verify the operation of a replacement drive
Steps
1. From PowerStore Manager, select Hardware.
2. Select the appliance where you replaced the drive.
3. On the Components card, under Drives, expand ExpansionEnclosure and select the drive.
SAS expansion enclosure service procedures
129
To Next Page
Loading...
