Remove a drive filler module
Steps
1. Insert your finger into the cutout on the drive filler module.
2. Pull the filler module out of the slot.
Figure 151. Removing a drive filler module
Installing a drive
About this task
NOTE:
If you are installing multiple drives in a system that is powered up, wait at least 10 seconds before sliding the next
drive into position.
NOTE: Drives must be installed from left-to-right starting with the first available slot.
Steps
1. Align the drive with the guides in the slot.
2. With the latch fully opened, gently push the drive into the slot.
The latch begins to rotate downward when it meets the enclosure.
3. Push the orange button until the drive is fully seated in the slot.
4. Push the latch down until it locks into place.
SAS expansion enclosure service procedures
125
To Next Page
Loading...
