Figure 174. Removing a drive
4. Place the drive on a static-free surface.
Installing a drive
About this task
NOTE:
If you are installing multiple drives in a system that is powered up, wait at least 10 seconds before sliding the next
drive into position.
NOTE: Drives must be installed from left-to-right starting with the first available slot.
Steps
1. Align the drive with the guides in the slot.
2. With the latch fully opened, gently push the drive into the slot.
The latch begins to rotate downward when it meets the enclosure.
3. Push the orange button until the drive is fully seated in the slot.
4. Push the latch down until it locks into place.
Figure 175. Installing a drive
The activity light flashes to indicate that the spin-up sequence has begun.
NVMe expansion enclosure service procedures
145
To Next Page
Loading...
