Figure 21. Installing the NVMe expansion enclosure rails (front)
5. Add the retaining screws that came with the rails to the front and back of both rails.
NOTE: Use the washers that came with the rails if the rack holes are square.
NOTE: The screw hole at the front of the rail is behind the rail clamp.
NOTE: You will need a long handled screwdriver to reach the screw hole at the rear of the rack.
NOTE: The following illustration does not show the C-clips that are used to attach the cable management arms.
Figure 22. Adding the retaining screws
32
Install a new base enclosure and an optional expansion enclosure
To Next Page
Loading...
