5. Continue to push firmly until the latch handle fully engages. You should hear a click as the latch handle engages and holds
the handle closed.
Figure 45. Installing an LFF drive carrier module (2 of 2)
6. Use the PowerVault Manager or CLI to verify the following:
● Health of the new disk drive is OK
● Green Disk Activity LED is on/blinking
● Ops panel states show no amber module faults
Replacing an SFF drive carrier module
The replacement procedures for SFF drive carrier modules are the same for LFF modules, except that the SFF drive carrier
modules are mounted vertically.
Removing an SFF drive carrier module
Perform the following steps to remove an SFF drive carrier module from a 2U enclosure:
1. Press the latch on the drive module carrier to open the handle.
Figure 46. Removing an SFF drive module carrier (1 of 2)
2. Gently move the drive carrier module approximately 25 mm (1 in.), and then wait 30 seconds for the drive to spin down.
50
Module removal and replacement
To Next Page
Loading...
