Figure 47. Removing an SFF drive module carrier (2 of 2)
3. Remove the drive carrier module from the drive slot.
CAUTION: To ensure optimal cooling throughout the enclosure, blank drive carrier modules must be installed
in all unused drive slots.
Installing an SFF drive carrier module
Perform the following steps to install an SFF drive carrier module in a 2U enclosure:
1. Press the latch on the drive module carrier to open the handle.
Figure 48. SFF drive carrier module in open position
2. Insert the drive carrier module into the enclosure.
3. Gently slide the drive carrier module into the enclosure until it stops moving.
Module removal and replacement
51
To Next Page
Loading...
