Dell PowerVault Storage Area Network - Replication -Show; Peer_Name <Name>] [-Username <User Name>] [-Encryption <None | Aes128 | Aes256>]; Encryption <None | Aes128 | Aes256>] [-Username <User Name>]; Replication -Add -Name <Name> -Role <Source | Target> -Peer <Ip Address | Hostname Peer_Name <Name>] [-Username <User Name>] [-Encryption <None | Aes128 | Aes256>]

Result
Replication limits are enabled.
Host Name Target IP Speed Limit
acme-85 10.21.22.20 192 KBps
NOTE: You can limit the bandwidth consumed by the replication process by setting a value in kilobytes/second
(kbps), megabytes/second (mbps), gigabytes/second (gbps), or use an unlimited bandwidth (default). The minimum
allowed bandwidth setting for a DR Series system is 192 kbps.
For more information, see replication --limit --speed <<num><kbps | mbps | gbps> | default> --target <ip address |
hostname>.
replication --add --name <name> --role <source | target> --peer <ip address | hostname>
[--peer_name <name>] [--username <user name>] [--encryption <none | aes128 | aes256>]
Description
Adds a new replication link to a container on the DR Series system, for which you need to define its name, role, peer ID,
peer name, user name, and encryption level to apply. There are three options for encryption: none, aes128 (Advanced
Encryption Standard), using128-bit cryptographic keys, and aes256 (using 256-bit AES cryptographic keys).
NOTE: Make sure that the data container you intend to replicate already exists. If it does not, the following error
message displays: Error: Container <container_name> does not exist .
Syntax
replication --add --name backup --role source --peer 10.25.20.10 --encryption
aes128
Result
Enter password for administrator@10.25.20.10:
Replication configuration updated successfully.
Replication Container : backup
Replication Role : Source
Replication Target System : swsys-85
Replication Target System IP : 10.25.20.10
Replication Target Container : acme85-S2
Replication Enabled : Yes
Replication Compression Enabled : Yes
Replication Encryption : AES 128-bit
NOTE: To verify that you have successful added a replication link to the DR Series system (or to view the current
status of existing containers), see replication --show.
replication --update --name <name> --role <source | target> [--peer <ip address |
hostname>] [--encryption <none | aes128 | aes256>] [--username <user name>]
Description
Updates an existing replication link to a container in a DR Series system and allows you to change the corresponding
role, peer IP address or host name, the encryption being used, and user name based on the DR Series system CLI
command options you specify.
Syntax
replication --update --name backup --role source --peer 10.25.19.5
111