Dell PowerVault Storage Area Network - Replication -Start -Name <Name> -Role <Source | Target; Replication -Stop -Name <Name> -Role <Source | Target; Replication -Limit -Speed <<Num><Kbps | Mbps | Gbps> | Default> -Target <Ip Address | Hostname

replication --start --name <name> --role <source | target>
Description
Starts the replication process on an existing replication link to a container in a DR Series system.
Syntax
replication --start --name container2_replica --role target
Result
Replication configuration updated successfully.
Replication Container : container2_replica
Replication Role : Source
Replication Target System : acme-85
Replication Target System IP : 10.20.22.20
Replication Target Container : acme85-S2
Replication Enabled : Yes
Replication Compression Enabled : Yes
Replication Encryption : AES 128-bit
replication --stop --name <name> --role <source | target>
Description
Stops the replication process on an existing replication link to a container in a DR Series system.
Syntax
replication --stop --name acme-59_replicate --role source
Result
Replication configuration updated successfully.
Replication Container : acme59
Replication Role : Source
Replication Target System : acme-85
Replication Target System IP : 10.20.22.20
Replication Target Container : acme85-S2
Replication Enabled : No
Replication Compression Enabled : Yes
Replication Encryption : AES 128-bit
replication --limit --speed <<num><kbps | mbps | gbps> | default> --target <ip address |
hostname>
Description
Limits the bandwidth used during replication by defining a bandwidth limit using any of the following settings:
• Kilobytes/second (kbps)
• Megabytes/second (mbps)
• Gigabytes/second (gbps)
• Unlimited bandwidth (this is the default setting); minimum allowed bandwidth setting is 192 kbps
Configures replication limits for a DR Series system.
113