• Ping a destination host
• Perform basic troubleshooting
• Configure TCP packet filter operations based on port type, packet size, file size, and host
• Test network performance between any designated client and server on the network
Network Command Usage
This topic introduces the network command usage:
• network --show
• network --restart
• network --setdhcp
• network --setstatic_ip [options]
• network --setdns [options]
• network --setbonding [options]
• network --nslookup [options]
• network --traceroute [options]
• network --ping [options]
• network --troubleshoot [options]
• network --tcpdump [options]
• network --iperf_client [options]
• network --iperf_server [options]
• network --help
NOTE: If you specify a command without supplying the expected value or option, you will be prompted to provide
the correct value or option.
network --show
Description
Displays the current networking configuration for a DR Series system.
Syntax
network --show
Result
Device : bond0
Boot protocol : dhcp
IP Addr : 10.20.24.55
Netmask : 255.255.252.0
Gateway : 10.20.32.13
MAC Addr : 78:2B:CB:47:D0:08
MTU : 1500
Bonding options : "mode=balance-alb miimon=100 xmit_hash_policy=2"
Slave Interfaces : eth0,eth1,eth2,eth3
eth0 MAC : 78:2B:CB:47:D0:08
eth0 Max Speed : 1000baseT/Full
eth0 Speed : 1000Mb/s
eth0 Duplex : Full
eth1 MAC : 00:50:56:93:5A:02
eth1 Max Speed : 1000baseT/Full
35
To Next Page
Loading...
