Dell PowerVault Storage Area Network - System -Datacheck Command Usage; System -Datacheck; System -Datacheck [-Disable <All | Namespace | Blockmap>]

System --Datacheck Command Usage
This topic introduces the system --datacheck command usage:
• system --datacheck
• system --datacheck--enable [options]
• system --datacheck --disable [options]
• system --datacheck --throttle [options]
• system --help datacheck
NOTE: If you specify a command without supplying the expected value or option, you will be prompted to provide
the correct value or option.
system --datacheck
Description
Displays the current status of Data Check on a DR Series system.
Syntax
system --datacheck
Result
Data Check : Enabled - namespace,blockmap,throttle:50%
NOTE: This example shows that both --namespace and --blockmap scans are enabled, and the default --throttle
setting (50%) is on for the DR Series system.
However, if both Data Check scans are disabled on a DR Series system, the following output status is displayed when
the system --datacheck command is used:
system --datacheck Data Check : Disabled
NOTE: A Data Check status of disabled indicates that both the --namespace and --blockmap scans are disabled on
the DR Series system.
system --datacheck [--disable <all | namespace | blockmap>]
Disables one or both Data Check scan option types that can be used on a DR Series system. You can individually disable
namespace or blockmap scan options, or both options using the all scan option (which means that both the namespace
and blockmap scan types will be disabled).
Description
Disables an individual Data Check scan option type (or both scan types) when used in a DR Series system CLI command.
Syntax
system --datacheck --disable all
Result
Data Check configuration successful: all scans currently disabled.
124