Steps
1. Align and place the antenna on the SMA connector of the system unit.
2. Tighten the nut at the bottom of SMA antenna to secure the antenna to the system unit.
3. Turn the antenna at a convenient angle as per the deployment infrastructure.
Next steps
1. Follow the procedure in after working inside your computer.
Side cover
Removing the side cover
Prerequisites
1. Follow the procedure in before working inside your computer.
NOTE: Ensure that you remove the security cable from the security-cable slot (if applicable).
About this task
The following images indicate the location of the side cover and provide a visual representation of the removal procedure.
Disassembly and reassembly
23
To Next Page
Loading...
