7. Remove the solid-state drive.
8. Remove the WLAN card.
9. Remove the speaker.
10. Remove the fan assembly.
11. Remove the memory modules.
12. Remove the riser card.
13. Remove the heat sink.
14. Remove the interposer module.
15. Remove the system board.
About this task
The following images indicate the location of the internal antenna and provide a visual representation of the removal procedure.
Steps
1. Pry the metallic routing tabs and unroute the antenna cables from the chassis.
2. Loosen and remove the single screw (M3x3) securing the internal antenna to the chassis.
Installing the Internal antenna
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
80
Disassembly and reassembly
To Next Page
Loading...
