About this task
The following image indicates the location of the Internal antenna and provides a visual representation of the installation
procedure.
Steps
1. Align and replace the SMA antenna connector on the rear of the chassis and secure it using the single M3x3 screw to the
chassis.
2. Route the antenna cable along the metallic guide path on the chassis.
Next steps
1. Install the system board.
2. Install the interposer card.
3. Install the heat sink.
4. Install the riser card.
5. Install the memory modules.
6. Install the speaker.
7. Install the fan assembly.
8. Install the WLAN card.
9. Install the solid-state drive.
10. Install the hard drive assembly.
11. Install the front bezel.
12. Install the SMA antenna.
13. Install the top cover.
14. Install the side cover.
15. Follow the procedure in after working inside your computer.
Disassembly and reassembly
81
To Next Page
Loading...
