Steps
1. Place the hard drive into the bracket.
2. Align and insert the pins on the drive bracket with the slots on the drive.
NOTE: Note the orientation of the hard drive so that you can replace it correctly.
Next steps
1. Install the 2.5 in. hard-drive assembly.
2. Install the front bezel.
3. Install the top cover (side bezel).
4. Install the side cover.
5. Follow the procedure in after working inside your computer.
Installing the 2.5 in. hard drive assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the hard drive assembly and provides a visual representation of the installation
procedure.
34
Disassembly and reassembly
To Next Page
Loading...
