Figure 5. Heat sink shipped with system configuration shipped with 80 W CPU
Steps
1. Loosen the three captive screws that secure the heat sink to the system.
NOTE: Loosen the screw in the sequential order (3,2,1) as printed on the heat sink.
2. Lift the heat-sink from the system board.
Installing the heat sink
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the heat sink and provides a visual representation of the installation procedure.
60
Disassembly and reassembly
To Next Page
Loading...
