Dell Precision 3240 Compact - System Board Removal and Installation

About this task
The following image indicates the location of the interposer module and provides a visual representation of the installation
procedure.
Steps
1. Align and replace the interposer module on the system board.
2. Replace the single screw (M3x5) and connect the SATA cable to the connector on the system board and close the actuator.
Next steps
1. Install the riser card.
2. Install the fan assembly.
NOTE: This step is valid for system configuration that is shipped with 80 W CPU.
3. Install the front bezel.
4. Install the top cover (side bezel).
5. Install the side cover.
6. Follow the procedure in after working inside your computer.
Processor
Removing the processor
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the top cover (side bezel).
4. Remove the front bezel.
5. Remove the fan assembly.
6. Remove the heat sink.
64
Disassembly and reassembly