Dell Precision 3240 Compact - Graphics Card Removal and Installation

About this task
The following image indicates the location of the solid-state drive and provides a visual representation of the installation
procedure.
Steps
1. Align the notch on the solid-state drive with the tab on the solid-state drive connector on the system board.
2. Insert the solid-state drive at a 45-degree angle into the solid-state drive connector.
3. Replace the screw (M2x3.5) that secures the M.2 2280 PCIe solid-state drive to the system board.
Next steps
1. Install the hard-drive assembly.
2. Install the riser card.
3. Install the fan assembly.
NOTE: This step is valid for system configuration that is shipped with 80 W CPU.
4. Install the front bezel.
5. Install the top cover (side bezel).
6. Install the side cover.
7. Follow the procedure in after working inside your computer.
Optional IO card
Removing the optional I/O card
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the top cover (side bezel).
4. Remove the front bezel.
5. Remove the hard drive assembly.
Disassembly and reassembly
53