About this task
The following image(s) indicate the location of the 2.5-inch hard-drive assembly and provides a visual representation of the
removal procedure.
Steps
1. Place the computer on its side with the left side facing up.
2. Press the release tabs on the hard-drive caddy and slide the hard-drive caddy out to disconnect from the connector on the
system board.
3. Lift the hard-drive assembly from the computer.
NOTE: Note the orientation of the hard drive so that you can replace it correctly.
Removing the 2.5-inch hard-drive caddy
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
18
Removing and installing components
To Next Page
Loading...
