Steps
1. Align the screw holes on the riser card with the screw holes on the chassis.
2. Replace the two (M3x5) screws to secure the riser card to the chassis.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
Wireless card
Removing the wireless card
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the hard-drive assembly.
About this task
The following image(s) indicate the location of the wireless card and provide a visual representation of the removal procedure.
24
Removing and installing components
To Next Page
Loading...
