Dell Precision 3260 Compact - Installing the 2.5-Inch Hard-Drive Assembly

Steps
1. Place the 2.5-inch hard drive into the hard-drive caddy and align the tabs on the caddy with the slots on the hard drive.
2. Snap the hard-drive caddy onto the 2.5-inch hard drive.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
Installing the 2.5-inch hard-drive assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image(s) indicate the location of the 2.5-inch hard-drive assembly and provide a visual representation of the
installation procedure.
20
Removing and installing components