Steps
1. Remove adhesive tape and place the Aux antenna stand off into the hole on the chassis.
2. Align the antenna module screw hole with the screw hole on the chassis.
3. Replace the single screw (M3x3) to secure the internal antennae to the chassis.
4. Route the antenna cable through the metallic routing guide on the computer.
Next steps
1. Install the wireless card.
2. Install the riser card—optional.
3. Install the hard-drive assembly—optional.
4. Install the side cover.
5. Follow the procedure in after working inside your computer.
Removing the SMA antenna—Location 3
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
Removing and installing components
69
To Next Page
Loading...
