About this task
The following image(s) indicate the location of the solid-state drive and provides a visual representation of the installation
procedure.
Steps
1. Align the notch on the 2230 solid-state drive with the tab on the M.2 card slot on the system board.
2. Slide the 2230 solid-state drive into the M.2 card slot on the system board.
3. Replace the screw (M2x3.5) that secures the 2230 solid-state drive to the system board.
4. Place the computer in an upright position.
Next steps
1. Install the hard-drive assembly.
2. Install the riser card—optional.
3. Install the processor fan.
4. Install the side cover.
5. Follow the procedure in after working inside your computer.
Removing the M.2 2280 PCIe solid-state drive (slot-0)
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the processor fan.
4. Remove the riser card—optional.
Removing and installing components
39
To Next Page
Loading...
