NOTE: If the memory module is difficult to remove, gently ease the memory module back and forth to remove it from
the slot.
Installing the memory modules
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image(s) indicate the location of the memory modules and provide a visual representation of the installation
procedure.
Steps
1.
NOTE:
The thermal pad is applicable only for computers with 32 GB x 2 configuration, install the thermal pad before
installing the 32 GB x 2 memory module.
Align the notch on the memory module with the tab on the memory-module slot.
2. Insert the memory module into the memory-module slot.
3. Press down on the memory module until the memory module snaps into position and the securing clip locks in place.
CAUTION:
To prevent damage to the memory module, hold the memory module by the edges. Do not touch
the components on the memory module.
NOTE: The securing clips return to the locked position. If you do not hear the click, remove the memory module and
reinstall it.
Removing and installing components 33
To Next Page
Loading...
