Steps
1. Align the screw hole on the SATA FFC module with the screw hole on the system board.
2. Replace the single screw (M3x5) that secures the SATA FFC module to the system board.
3. Connect the SATA FFC to the connector on the system board and close the latch.
Next steps
1. Install the hard drive.
2. Install the processor fan.
3. Install the side cover.
4. Follow the procedure in after working inside your computer.
Processor
Removing the processor
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the processor fan.
4. Remove the heat sink.
About this task
The following image(s) indicate the location of the processor and provide a visual representation of the removal procedure.
Removing and installing components
55
To Next Page
Loading...
