Steps
1. Remove the single screw (M3x4) that secures the speaker holder to the system board.
2. Lift and remove the speaker holder away from the system board.
3. Remove the four screws (M3x4) that secure the system board to the chassis.
4. Remove the three screws (M2x4) that secure the system board to the chassis.
5. Slide and lift the system board away from the chassis.
Installing the system board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the connectors on your system board.
Removing and installing components
61
To Next Page
Loading...
