Dell Precision 3260 Compact - Page 72

8. Route the antenna cables through the routing guides on the sides of the system board.
9. Remove the cable-protective cover from the SMA antenna.
10. Use a screwdriver remove the upper filler in the SMA antenna holes on the chassis.
11. Insert the SMA antenna module through the bottom cover inside the chassis.
12. Tighten the nut using the 8 mm wrench or with automatic screw driver.
13. Replace the cable-protective cover to the SMA antenna.
Next steps
1. Install the riser card—optional.
2. Install the hard-drive assembly—optional.
3. Install the side cover.
4. Follow the procedure in after working inside your computer.
72 Removing and installing components