3. Remove the base cover.
4. Remove the battery.
5. Remove the ssd.
6. Remove the ssd bracket.
7. Remove the palmrest bracket.
8. Remove the LED board.
9. Remove the speaker.
10. Remove the heatsink.
11. Remove the memory module.
12. Remove the DC-in .
13. Remove the WLAN card.
14. Remove the system board.
15. Remove the coin cell battery.
16. Remove the keyboard.
17. Remove the SmartCard reader board.
About this task
After performing the preceding steps, you are left with the palmrest and keyboard assembly.
Next steps
1. Install the SmartCard reader board.
2. Install the keyboard.
3. Install the coin cell battery.
4. Install the system board.
5. Install theWLAN card.
6. Install the Dc-in.
7. Install thememory module.
8. Install the heatsink.
Disassembly and reassembly
107
This manual downloaded from http://www.manualowl.com
To Next Page
Loading...
