3. Reseat the LED board [1].
4. Replace the one (M2x2.5) to secure the LED board to the computer [2].
Next steps
1. Install the palmrest bracket.
2. Install the ssd bracket.
3. Install the ssd.
4. Install the battery.
5. Install the base cover.
6. Install the microSD card.
7. Follow the procedure in after working inside your computer.
Heat sink
Removing the Heatsink
Prerequisites
1. Follow the procedure in before working inside your computer
2. Remove the microSD card.
3. Remove the base cover.
4. Remove the battery.
Steps
1. Disconnect the Heatsink fan cable from the connector on the system board [1].
44
Disassembly and reassembly
This manual downloaded from http://www.manualowl.com
To Next Page
Loading...
