Dell Precision 3570 - Display Back Cover; Removing the Display Back Cover

Steps
1. Align and place the sensor board on the display back cover.
2. Connect the display cable to the connector on the sensor board and close the latch.
Next steps
1. Install the display panel.
2. Install the display bezel.
3. Install the display assembly.
4. Install the base cover.
5. Install the microSD card.
6. Install the SIM card.
7. Follow the procedure in after working inside your computer.
Display back cover
Removing the display back cover
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SIM card.
3. Remove the microSD card.
4. Remove the base cover.
5. Remove the display assembly.
6. Remove the display bezel.
7. Remove the display panel.
8. Remove the display hinges.
9. Remove the camera/microphone module.
10. Remove the eDP cable.
11. Remove the sensor board.
About this task
The following images indicate the location of the display back cover and provide a visual representation of the removal
procedure.
100
Removing and installing components