Steps
Pry and remove the M.2 2230 solid-state drive holder from the screw hole on the system board.
Installing the M.2 2230 solid-state drive holder
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the M.2 2230 solid-state drive holder and provides a visual representation of the
installation procedure.
Steps
Align and insert the solid-state drive holder on the system board to accommodate the M.2 2230 solid-state drive.
Next steps
1. Install the base cover.
2. Install the microSD card.
3. Install the SIM card.
4. Follow the procedure in after working inside your computer.
Installing the M.2 2230 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE: You can refer the below procedure to install the M.2 2230 solid-state drive in both SLOT 1 and SLOT 2.
NOTE: SLOT1 supports only PCIe Gen4 Solid-state drive and does not support any Intel Optane.
Removing and installing components 33
To Next Page
Loading...
