Steps
1. Connect the battery cable to the system board.
2. Align the screw holes on the base cover with the screw holes on the palm-rest assembly, and then snap the base cover into
place.
3. Tighten the eight captive screws that secure the base cover to the palm-rest assembly.
Next steps
1. Install the microSD card.
2. Install the SIM card.
3. Follow the procedure in after working inside your computer.
WLAN card
Removing the WLAN card
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SIM card.
3. Remove the microSD card.
4. Remove the base cover.
22
Removing and installing components
To Next Page
Loading...
