15. Lift the system board off the palm-rest assembly.
16. Flip the system board and disconnect the coin-cell battery cable from the connector on the system board.
Installing the system board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the system board and provides a visual representation of the installation procedure.
1. Fingerprint reader connector 2. WLAN connector
3. Camera/IR cable connector 4. eDP/display cable connector
5. Solid-state drive-SSD-1 slot 6. Touchpad cable connector
7. Battery cable connector 8. Memory modules
9. LED board connector 10. USH board connector
11. Solid-state drive-SSD-2 slot 12. WWAN connector
13. Speaker cable connector
Removing and installing components 65
To Next Page
Loading...
