Steps
1. Open the latch and disconnect the backlight cable and the keyboard cable from the connector on the touchpad.
2. Open the plastic tapes on the keyboard assembly to access the keyboard assembly screws.
3. Remove the twenty-six (M2x2) screws that secure the keyboard assembly to the palm-rest assembly.
4. Remove the keyboard assembly off the palm-rest assembly.
Installing the keyboard assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the keyboard assembly and provides a visual representation of the installation
procedure.
Removing and installing components
75
To Next Page
Loading...
