Removing and installing components
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Plastic scribe
Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Screw type Quantity Screw image
Base cover Captive screw 8
N/A
WLAN Captive screw 1
N/A
WWAN Captive screw 1
N/A
M.2 2230 solid-state drive M2x4 1
M.2 2280 solid-state drive M2x4 1
Assembly inner frame M2x3 12
3-cell battery Captive screws 3
N/A
4-cell battery Captive screws 3
N/A
Heat sink-integrated Captive screw
M2x3
4
1
Heat sink-discrete Captive screw
M2x3
7
1
2
Removing and installing components 11
To Next Page
Loading...
