Installing the keyboard bracket
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the keyboard bracket and provides a visual representation of the installation
procedure.
Steps
1. Align and place the keyboard on the keyboard bracket.
2. Replace the eleven (M2x2) screws to secure the keyboard to the keyboard bracket.
Next steps
1. Install the keyboard assembly.
2. Install the system board.
NOTE:
The system board can be installed with the heat sink attached in order to simplify the procedure and preserve
the thermal bond between the system board and heat sink.
3. Install the assembly inner frame.
4. Install the system fan.
5. Install the 3-cell battery or 4-cell battery.
6. Install the WWAN card.
7. Install the WLAN card.
8. Install the base cover.
9. Install the microSD card.
10. Install the SIM card.
11. Follow the procedure in after working inside your computer.
78
Removing and installing components
To Next Page
Loading...
