Dell Precision 3570 - Sensor Board; Removing the Sensor Board

Steps
1. Connect the eDP cable to the connector on the camera module.
2. Adhere the eDP cable to the display back cover.
3. Adhere the conductive tape and route the eDP cable to the display back cover.
Next steps
1. Install the display panel.
2. Install the display bezel.
3. Install the display assembly.
4. Install the base cover.
5. Install the microSD card.
6. Install the SIM card.
7. Follow the procedure in after working inside your computer.
Sensor board
Removing the sensor board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SIM card.
98
Removing and installing components