NOTE: If battery is disconnected from system board for service, then there is a delay during system boot-up as the system
undergoes RTC battery reset.
Steps
1. Align the screw holes on the battery with the screw holes on the palm-rest assembly.
2. Tighten the three captive screws to secure the battery to the palm-rest assembly.
3. Connect the battery cable to the connector on the system board.
Next steps
1. Install the base cover.
2. Install the microSD card.
3. Install the SIM card.
4. Follow the procedure in after working inside your computer.
Removing the 4-cell battery
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SIM card.
3. Remove the microSD card.
Removing and installing components
41
To Next Page
Loading...
