Steps
Place the palm-rest assembly on a flat surface.
Next steps
1. Install the dummy SIM-card slot filler (only for non-WWAN configuration).
2. Install the display assembly.
3. Install the keyboard assembly
4. Install the smart card reader.
5. Install the system board.
6. Install the assembly inner frame.
7. Install the system fan.
NOTE:
The system board can be installed with the heat sink attached in order to simplify the procedure and preserve
the thermal bond between the system board and heat sink.
8. Install the 3-cell battery or 4-cell battery.
9. Install the WWAN card.
10. Install the WLAN card.
11. Install the base cover.
12. Install the microSD card.
13. Install the SIM card.
14. Follow the procedure in after working inside your computer.
106
Removing and installing components
To Next Page
Loading...
