7. Remove the WLAN card.
8. Remove the WWAN card.
9. Remove the heat sink (integrated) or heat sink (discrete).
10. Remove the 3-cell battery or 4-cell battery.
11. Remove the system fan.
12. Remove the assembly inner frame.
About this task
The following images indicate the location of the system board and provide a visual representation of the removal procedure.
1. Fingerprint reader connector 2. WLAN connector
3. Camera/IR cable connector 4. eDP/display cable connector
5. Solid-state drive-SSD-1 slot 6. Touchpad cable connector
7. Battery cable connector 8. Memory modules
9. LED board connector 10. USH board connector
11. Solid-state drive-SSD-2 slot 12. WWAN connector
13. Speaker cable connector
Removing and installing components 61
To Next Page
Loading...
