Steps
1. Align and place the power-button board on the palm-rest assembly.
2. Replace the two screws (M2x2) that secure the power-button board to the palm-rest assembly.
Next steps
1. Install the system board.
NOTE:
The system board can be installed with the heat sink attached in order to simplify the procedure and preserve
the thermal bond between the system board and heat sink.
2. Install the assembly inner frame.
3. Install the system fan.
4. Install the 3-cell battery or 4-cell battery.
5. Install the WWAN card.
6. Install the WLAN card.
7. Install the memory module.
8. Install the M.2 2280 solid-state drive or M.2 2230 solid-state drive.
9. Install the base cover.
10. Install the microSD card.
11. Install the SIM card.
12. Follow the procedure in after working inside your computer.
70
Removing and installing components
To Next Page
Loading...
